Gnss Survey Rover — Rough Dozer Grade

GNSS Machine Control

GNSS machine control combines positioning, machine geometry and design information. An accurate receiver position is not automatically an accurate cutting-edge position.

Before moving material

Confirm corrections, sensor arrangement and the coordinate reference.

Receiving operation and checks

Check the completed surface with an independent method. Inspect offsets, design revision and correction status when results disagree.

Compatibility must be confirmed for the actual machine and control installation.

From Rough Grade to Fine Grade

Rough grading establishes the broad shape; fine grading corrects the remaining smaller deviations. Trying to finish while bulk quantities are still wrong can waste passes and disturb completed areas. The changeover should occur when levels are close enough, materials are suitable and the receiving surface is ready for controlled trimming.

Before moving material

Complete major excavation and isolate unsuitable ground.

Receiving operation and checks

Protect the finished area from uncontrolled traffic and schedule the next layer. Check local levels and continuity through joins, not only the average elevation.

Fine grading cannot rescue a weak formation hidden beneath a neat finish.

Machine Before - Dugong - Machine After

The machine before Dugong determines what material arrives; the machine after Dugong determines what surface must leave. An excavator can expose formation, a loader can deliver a stockpile, and a roller can compact the placed layer. The scraper's role is bounded by those interfaces.

Before moving material

Identify the upstream operation and its remaining defects.

Receiving operation and checks

Hand over the measured surface to compaction, cultivation, paving or turf preparation. Record which operation owns levels, materials and final acceptance.

The workflow can include Dugong where suitable; it does not assume Dugong replaces adjacent equipment.

Record the job inputs

Use this checklist to turn the scenario into a specific brief. Retain the design revision and agree who accepts each completed layer.

• Existing condition, extent and the reason for intervention
• Required finished purpose, receiving operation and acceptance criteria
• Material type, layer role, source, receiving area and volume state
• Reference levels, datum, survey method and issued design revision
• Available tractor, implement configuration, travel route and turning space
• Checks before work, stopping points and evidence retained at handover

Checklist ticks apply only while this page is open. Include the completed brief in your project records.

Continue through the network

Surface and verification · Applications and rental · Equipment and technology